Sniper AI   (3)

Price: $30.00

Availability: This product is back-ordered; it is unavailable for ordering at this time please come back or continue shopping.

 

A set of 3 Sniper AI robots. 
 

Sniper AI body measures approximately 24mm in diameter. 

Each AI consists of 7 resin parts and also includes a 2 part clear plastic base. 

 

This part is made from resin and is supplied unpainted and unassembled, color may vary from the picture. Clear plastic base is included

This item is not a toy and is not intended for children under the age of 12.

 

Some minor clean up and flash removal may be needed. It is suggested that you wash resin parts in soapy water with a mild dishsoap to remove any left over release agents and oils prior to painting.

Excessive heat may damage resin products. Do not leave resin parts in hot areas (such as a car) or in direct sunlight as it may damage the model or cause the parts to warp. Warped resin items can usually be straightened by soaking the part in a cup of hot water (not boiling) until it becomes soft, then carefully bending the part back into proper shape then allowed to cool. 

 

Assembly Tips:

When removing the sprue on the back side of the model there is a slight wedge shape and you'll want to make sure your cuts are done to match that angle as best possible. If you cut it flat across the back the engine port won't sit flush against it so pay attention to the contour. 
 
The Sniper's gun needs to have the peg hole made slightly deeper, use either a 2mm or 2.5mm drill bit for that. A 2mm bit works but is very tight and could snap the peg if you force it. 
 
The red lines indicate the suggested angles for how you should make the cuts