Gunner AI Drone (3)

Price: $15.00

Sale Price: $10.00

Availability: in stock

A set of 3 Gunner AI robots.

Does not include flying base. You will need to purchase a 3mm peg base elsewhere. GW and Litko have bases available.

Gunner AI body measures approximately 24mm in diameter.

Each AI consists of 6 resin parts.

This part is made from resin and is supplied unpainted and unassembled, color may vary from the picture.

This item is not a toy and is not intended for children under the age of 12.

Some minor clean up and flash removal may be needed. It is suggested that you wash resin parts in soapy water with a mild dishsoap to remove any left over release agents and oils prior to painting.

Excessive heat may damage resin products. Do not leave resin parts in hot areas (such as a car) or in direct sunlight as it may damage the model or cause the parts to warp. Warped resin items can usually be straightened by soaking the part in a cup of hot water (not boiling) until it becomes soft, then carefully bending the part back into proper shape then allowed to cool.

Assembly Tips:

When removing the sprue piece on the back of the model there is a slight wedge shape and you'll want to make sure your cuts are done to match that angle as best possible. If you cut it flat across the back the engine port won't sit flush against it so pay attention to the contour.

The red lines indicate the suggested angles for how you should make the cuts